Super-strong universal contact adhesive based on neoprene rubber. For innumerable repair and DIY jobs that require immediate bonding. Extremely suitable for materials under strain. Moisture and frost proof. Resistant to temperatures between -15 °C and +70 °C.

Suitable for:
Ideally suited for surface bonding or laminating of many materials that require immediate bonding, loading or processing.
Bonds wood, board, veneer, plastic and metal panel boards (HPL, Formica®, for example), (foam) rubber, leather, cork, canvas, linoleum and polyether foam (sound insulation), among other things, to itself as well as to many other surfaces.
Also for repairing shoes, bags, toys and carpets, or for doing (hobby) handicraft work.

Not suitable for: Polystyrene foam (Tempex®), PE, PP, PTFE and vinyl.

Working conditions: Use adhesive and parts to be bonded at room temperature only. The relative humidity must be below 65 %. This is to avoid formation of bubbles in the final product. Once attached, adjustment is no longer possible. Always test on an (inconspicuous) part of the surface first.
Surface requirements: Surfaces must be dry, clean, dust- and grease-free and a good fit.
Preliminary surface treatment: Clean and degrease the surfaces to be bonded for optimal results.
Tools: Use a solid brush or fine-toothed (1 mm) glue spreader to cover large surfaces. Use a roller or rubber mallet to join the materials firmly.
Preparation of product: Stir well before use. Should preferably not be diluted
Coverage: 2 - 2.5 m²/litre, applied on both sides, depending on the nature of the materials to be bonded.

Directions For Use
Parts must be clean, dry and free of grease.
Coat both substrates completely.
Allow to dry for a minimum of 10 - 40 minutes.
In case of porous materials, apply a second coat and let dry.
Then join parts and roll or tap firmly (with a rubber mallet).

Points of attention
For optimum results, both the adhesive and the parts to be bonded must be at room temperature (definitely do not use below +10 °C).
The final bonding strength depends on the pressure applied.
Therefore, press as firmly as possible across the entire surface.
Should the adhesive joint between porous materials be exposed to long-lasting contact with water, the adhesive may detach from the wet surface.
Stains/residue: Remove fresh adhesive residue immediately with Acetone. Dried adhesive residue can only be removed mechanically or with a paint remover (test first).

Storage conditions: Store properly closed in a cool and frost-free place. Shelf life is a minimum 24 months.

Allowing your children to partake in arts & crafts early in life has been found to not only stimulate their senses but also aid in their mental and social development. Cultivating your little one's love for arts & crafts also helps them showcase their self-expression and boost their self-esteem. With this paint sets, they can start their painting journey! Whether they need it for school or simply love painting, this acrylic paint set comes with 12 assorted colours. It is the perfect gift for your young and aspiring little Van Gogh!

A range of colour pencils with ultra-resistant leads: Ø 3.2 mm (Ø 4 mm for jumbo pencils).

According to our in-house tests, these pencils have a lead 37% stronger than Star Colour pencils

Universal strong dual-component epoxy adhesive for repairing metal, pottery, porcelain, glass, pearls, precious stones and various synthetics. Temperature resistant, water resistant, chemical resistant and paintable.

Application
Suitable for: Repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex®).
Not suitable for: Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

Handling
Before use: Working conditions- Only apply at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and the hardener.
Surface requirements: The surface must be dry, clean and free of dust and grease.
Preliminary surface treatment: Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper).
Tools: Mix the components by means of the supplied mixing bowl and spatula.
Mixture ratio: 1:1
Coverage: 1 ml = approx 10 cm² at a film thickness of 1 mm

Directions For Use:
Press out an equal amount of both components onto the enclosed mixing tray.
Mix these two equal parts well with a spatula until a mixture is obtained with a homogeneous colour.
Apply the mixture, which at room temperature (+20 °C) remains toolable for about 1.5 hours, as a thin layer on one of the two materials.
Join the materials and keep them in place for 7 hours.
Be careful not to move the parts before the adhesive has cured.
Resin and hardener must not come into contact with each other unless for usage.

Advice
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

Points of attention
Close well after use.
For optimum performance it is important to create a larger amount of adhesive and mix it very well.
Curing time depends on the temperature.
Adhesive does not cure below +5 °C.
Stains/residue: Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions: Store in tightly closed packaging in a dry, cool and frost-free place.

Pentel is an international stationery brand recognised by consumers globally and is renowned for its innovation and quality products.
Pentel boasts a wide range of ballpoint pens, mechanical pencils, correction products (fluid & tape), markers and art materials.

Pentel Oil Pastels are brilliant, fade-resistant colours. Ideal for most types of paper. Slow drying time, means you can work on a piece for several weeks. Pastels apply smoothly and blend easily using cotton buds, fingers or tortillon for subtle shades, tints and colour mixture (can also be blended with mineral spirits or thinners).

Great to use in conjuction with watercolours.

The instantly recognizable STABILO point 88 fineliner is a timeless classic, with over 6 billion pieces sold and loved by so many all over the world. No matter whether you wish to structure your texts, underline, take notes or write full texts, our wide range of 47 brilliant colors, including 6 neon shades will have you covered. An 0.4mm line width and excellent quality make this a product you can rely on and enjoy using every day.

The STABILO point 88 is the perfect companion for schoolchildren, students and professionals. First released in 1977, this product is appreciated around the globe for its quality and usability. In Europe it’s the most popular fineliner available. The famous hexagonal body shape of the STABILO point 88 makes it very comfortable to grip. A choice of 47 colors means there will always be the ideal shade for your needs. If you wish to create a bigger impact, 6 neon colors available. Thanks to the long cap-off time you won’t have to worry if you accidentally leave it off.

Colourful Monster Themed Pencil Crayons

TOWER makes office organisation quick and easy.

Whether you are in the office or your home-office, we give you the tools to create the space you want.

Organise by colour, tidy and label according to your style – our products help you to personalise your space and make organisation an effortless part of your life.